problem with the scn5 configuration

Topics and questions about actuators etc.

problem with the scn5 configuration

Postby debek » Sat 20. Jan 2018, 01:44

hi, I have a problem with the x-sim setting of the converter, and specifically the setting of the actuators in this program. They are detected, calibrated when switched on, but I can not enter the "open setting" door in which I would like to bury. A screenshot below
Posts: 2
Joined: Sat 20. Jan 2018, 01:29
Has thanked: 0 time
Been thanked: 0 time

Return to Actuators

Who is online

Users browsing this forum: No registered users and 1 guest